Sewage Pumping Stations and It’s Uses

A Sewage Pump Station Monitoring is a very significant device in disposing of waste. This waste is detrimental to the environment and so it's vital to dealt with it properly.

The Procedure

A sewage pumping station, otherwise transferred to as a lift station, is mainly used for dealing with raw sewage. This reaches the station through an underground gravity pipeline system. This system is created of pipes which are placed at such an angle so that the sewage can flow unidirectional under gravity.

The sewage goes into an underground pit, identified as a wet well, and here it's stored. To prevent the pit from overflowing, it holds equipment which is capable to supervise the height of the sewage inside it. If it should increase above a certain level, a pump begins to drive it out into a specialized pipe system coined a sewer force main. From here it moves into a gravity manhole. This cycle continues until the sewage reaches its final destination, that is, a sewage treatment plant.

The Utilizes

In brief, a sewage pumping station is used to pump sewage from a lower region to a higher one. They can be used basically because they're the cheaper option. Examples are in cases where it creates more economic sense to pump it over a ridge and then let it flow naturally due to gravity into a sewage treatment plant or by lifting the sewage high enough to move through a sewage treatment plant again using gravity. Alternatively, they're useful in cases where a hydraulic head wouldn't be adequate.

The Setup

A lot of a time, sewage pumping plants can be place together as an assembled package. The major part required is a sewage treatment receiving well, which is otherwise known as the wet well. This comes with lift pumps, a junction box, piping containing valves, and a control panel which is equipped with an alarm system.

Traditional sewage pumping stations or Sewage Pump Station Monitoring have a wet well and a dry well. Usually, both these wells are in the same area and are then divided internally. The main concern about these is that if a pump or pipe is to leak the sewage, it could easily get into the dry well causing flooding. This is why the electric motors tend to be on the surface within pump houses to protect them from the elements.

Nowadays, a submersible type of pumping station is more common. The advantages are that they're usually less expensive and don't need much pump maintenance. They're also less of an eyesore as they don't tend to have large structures that can be seen above the ground. In addition, they carry much less health and safety risks.

Sewage treatment is vitally important. Such plants insure that sewage is treated properly before the water is deemed safe to be released into the environment.

Sewage pumping stations are an important part of a sewerage system. Their main role is to pump the sewage from a low point in a system to allow the sewage to reach to a sewage treatment plant.

In Conclusion:

Monitoring of sewage pump stations has become a very large part of our business for several reasons. First, customers need to know of problems immediately, especially power problems and high wet well levels. In most states, cities, towns and counties are required to visit any pump station not being monitored on a daily basis. Monitored sites require weekly visits in most cases. Browse our website to know about Sewage Pump Station Monitoring.